CME with Off Hook Alarm via TCL API

Re: New Message from Raghavendra Gutty Veeranagappa in Voice Gateway API (V

2012-05-18T14:20:53Z

From: Cisco Developer Community Forums [mailto:cdicuser@developer.cisco.com] Sent: Friday, May 18, 2012 07:33 AM To: cdicuser@developer.cisco.com Subject: New Message from Raghavendra Gutty Veeranagappa in Voice Gateway API (VGAPI) - TCL-API: RE: TCL/IVR script (incoming E1, plays a message and forwards call) Raghavendra Gutty Veeranagappa has created a new message in the forum "TCL-API": -------------------------------------------------------------- Hi Michal, need to remove the act_Cleanup procedure after leg setup, try with the attached script. Thanks, Raghavendra -- To respond to this post, please click the following link: or simply reply to this email. Information contained in this email is subject to the disclaimer found by clicking on the following link: http://www.lyondellbasell.com/Footer/Disclaimer/

RE: CME with Off Hook Alarm via TCL API

2012-03-26T23:39:42Z

Would it be possible to match a diall-peer if no digits were dialed from the ephone on CME? Then we could use TCL to transfer/forward to a destination. thanks, CJ

CME with Off Hook Alarm via TCL API

2012-03-12T15:41:08Z

Is it possible with TCL to have the IP Phone dial a phone number if the phone is taken off-hook but no digits are dialed? We have a scenerio in which the IP Phone needs to dial an emergency number if it goes off-hook but no digits are dialed. Once we hit the first digit timer instead of getting busy tone we need to dial a phone number. Does anyone know if this is possible with TCL?