« Back to Technical Questions

Development authorization is not valid before 2008-01-01

Combination View Flat View Tree View
Threads [ Previous | Next ]
Post New Thread
Development authorization is not valid before 2008-01-01
Answer
10/9/08 12:53 PM
I am trying to install an application in my AXP using:
"software install add url ftp://10.0.0.11/test_app.1.0.pkg"
and it returns me the following message:

Validating new manifest file /dwnld/pkgdata/test_app.1.0.pkg from package /dwnld/pkgdata/test_app.1.0.pkg
Validation Failed: Development authorization is not valid before 2008-01-01T00:00:00+00:00
Package signature validation failed for test_app.1.0.pkg

Then i am trying the following:
myAXP-blade> sho clock
04:38:11.646 EEST Fri May 05 2006
myAXP-blade> conf t
Enter configuration commands, one per line. End with CNTL/Z.
myAXP-blade(config)> clock timezone America/New_York
Save the change to startup configuration and reload the module for the new timezone to take effect.
myAXP-blade> show clock
21:41:35.904 EDT Thu May 04 2006

I am trying also to set an ntp server (nist1.columbiacountyga.gov 68.216.79.113 Columbia County, Georgia) but i get the following message:

WARNING!!! Could not reach 68.216.79.113 using NTP.
WARNING!!! 68.216.79.113 might not have been configured as
WARNING!!! NTP server.
WARNING!!! NTP Server 68.216.79.113 Will be entered in the NTP List

Is there any "clock set" functionality in order to set manually the date/time?

Thanks in advance
George
Flag

Re: Development authorization is not valid before 2008-01-01
Answer
10/9/08 9:13 PM as a reply to George K.
George,

You can do the following to correct date / time on AXP blade

Step 1 On the router:
a. Configure the ISR as an NTP master server.

configure terminal
ntp master

b. (Optional) ntp server {hostname|ip-address}
This step is optional, but recommended. Use this command to set an external server as the source for providing clock synchronization.

c. Configure the correct time zone on the router.

clock timezone zone
copy running-config startup-config
exit

Step 2 On the Cisco AXP service module:
a. Configure the Cisco AXP service module’s NTP server to point to the source router providing the clock synchronization.

configure terminal
ntp server router-ip address
end
write memory or copy running-config startup-config

b. Configure the time zone on the Cisco AXP service module to be the same as the source router time zone. Reload the module for the new time zone to take effect.

configure terminal
clock timezone
end
write memory or copy running-config startup-config
reload
Flag

Re: Development authorization is not valid before 2008-01-01
Answer
10/10/08 12:26 PM as a reply to George K.
Thank you very much for your reply.
It solved the "clock" issue.

George
Flag