How to configure an Agent to Automatically Log in after Failover http://developer.cisco.com/c/message_boards/find_thread?p_l_id=&threadId=8457777 2013-05-19T13:29:14Z 2013-05-19T13:29:14Z David Lender http://developer.cisco.com/c/message_boards/find_message?p_l_id=&messageId=8457920 2012-11-09T20:51:48Z 2012-11-09T20:51:48Z

Logging in the agent after failover is the standard behavior. There is also a registry setting for the Connection profile on CTIOS Server. AutoLogin is one of the registry settings. See the CTIOS System Manager’s Guide section on Defining Connection Profiles. The only other configuration I am aware of for failover is the PG Configuration using the LOAD /0 See the CTIOS System Manager’s Guide section on Failover. This setting causes agents to remain in the NotReady state during failover and for UCCE should not be changed.

David Lender 2012-11-09T20:51:48Z Arthur Shats http://developer.cisco.com/c/message_boards/find_message?p_l_id=&messageId=8457776 2012-11-09T20:31:28Z 2012-11-09T20:31:28Z

According to the documentation, to configure an agent to automatically log in again in the event of a failover, I have to set CTIOS_AUTOLOGIN parameter to 1 when I configure the agent. I am NOT doing it, but it seemed like it still failed over. It must be that the automatic failover is set somewhere else? Where could it set? Thanks.

Arthur Shats 2012-11-09T20:31:28Z