Hello,
 
  I need to record the calls (only audio). I know I can start the recording by using the CIL SDK, but I read I need an application registered as a "Cisco:CallRecording" service, based on "CTI Server Message Reference Guide (Protocol Version 13)" document.
 
  I wanted to know if there is a SDK available to use for this or if I have to develop my own logic to connect and send messages to the CTI Server. If so, should I connect to the CTI Server (tcp socket) and then send those messages in binary format?
 
Thanks in advance.
Damian N.
 
 
 

Hi.
 
Once my module (let's say X) gets registered against the Cti Server in order to record calls from server side:
 
a) will the RTP packets arrive to X?
b) will the RTP packets arrive from the Client application (Agent), or actually, it will receive the RTP packets from the Cti Server?
c) may we use the monitoring session from Cisco CIL (.NET) in order to invoke the StartRecord method?
 
Regards
Damian N.

Hello David,

  Thanks for your support.
  About the "Trunk Info" solution that you mentioned.

  Basically, we'd have to configure a "SIP Trunk" between some Cisco Component (which one?) and our recorder application. a) right?

  Then, when we need to record some extension (let's say A), we make a "conference" with A. Then we should start receiving RTP packets from an Audio Gateway regarding A. b) right?

  The fact of establishing a "SIP Trunk" is to avoid registering a bunch of extensions with some Cisco Component (which one?) to be able to record the productive extensions (I mean with "productive" the real extensions that are being used by a real call between an Agent and a Customer). c) right?

  The RTP packets will arrive to the port that was informed in the "conference" operation. I mean, I think that when you are using SIP you send an INVITE message (SIP) with the information where you will receive RTPs (SDP). d) Is this the same for this "conference" stuff?


Thanks in advance.
Regards!
Damian N.