MediaSense Forums

« Back to Technical Discussion

RE: Primary Server Post Installation

Combination View Flat View Tree View
Threads [ Previous | Next ]
Primary Server Post Installation
post installation
Answer
12/11/11 12:21 PM
Hi,
In the installation manual, it mentions "Post Installation" procedure, but I can't see any reference as to how to kink start this process. After installtion, all I get is the CLI login prompt. But according to the docs, I should "see the Cisco Media Sense First Server Setup Wizard". I see no such thing. I have installed twice to see if I missed anything, but I don't think I did. I was also supposed to see a link of some sort.
Any help will be appreciated.
Thanks.
Flag

RE: Primary Server Post Installation
Answer
12/11/11 10:01 PM as a reply to Chikeobi Njaka.
Hello Chikeobi,

You need use a browser to connect to the Administration UI by pointing your browser to http://<hostname or ip address>

Regards,
Nick
Flag

RE: Primary Server Post Installation
Answer
12/13/11 12:40 AM as a reply to Karamjit Singh.
Hello Chikeobi,

You need use a browser to connect to the Administration UI by pointing your browser to http://<hostname or ip address>

Regards,
Nick


Hi Nick,
Fiannly got it to work. Don't know what I did wrong. I now face a different problem. I can't seem to configure the Call Control Service Provider. Screen shot is provided.
Thanks.
Attachments:
Flag

RE: Primary Server Post Installation
Answer
12/13/11 8:01 PM as a reply to Chikeobi Njaka.
Hello Chikeobi,
 
You may be receiving this error because you might not have configured the DNS server at the time of installation.
 
You should try condiguring the DNS server using the "set network dns" CLI command and try this screen again.
 
Thanks,
Mayank
 
Flag

RE: Primary Server Post Installation
Answer
12/14/11 12:54 AM as a reply to Mayank Agarwal.
Hello Chikeobi,
 
You may be receiving this error because you might not have configured the DNS server at the time of installation.
 
You should try condiguring the DNS server using the "set network dns" CLI command and try this screen again.
 
Thanks,
Mayank
 

Hi Mayank,
I didn't configure DNS because step 14 in the installation says to set it to NO. In anycase, setting it to yes would mean also configuring reverse lookup. That is problematic in my environment.
I did configure it, though and the problem persists.
Flag