Time of Day Step

Use the Time of Day step to cause the script to branch to different connection branches depending on the current time of day.

Time of Day Customizer Window

Steps that you add following a specific output branch will execute if the Cisco Unified CCX Engine clock indicates that the time of day matches the time associated with that connection.

You associate each output branch with a specified range of time.

During run time, if the current time falls out of the configured time range, the script follows the Rest output branch of the Time of Day step.

Note

When you debug this step on a remote workstation, the Cisco Unified CCX Editor uses the time zone of the Cisco Unified CCX server where the script is being debugged.

All scripts that use the Time of Day step must be opened, saved, and uploaded again to the Unified CCX system for any changes in the time zone to take effect. This is applicable for any time zone selected other than TZ[primary] or TZ[local].

The following table describes the properties of the Time of Day customizer window:

Property

Description

Time Zone

You can configure the Time zone that you want the current step to use.

Note	List of time zones can be viewed from the Time zone tab in the Expression editor.

Connections

Output branches that execute depending on specified time of day.

Note	Specified through the Connection Name field in the Add Connection Name dialog box.

(Connection) Add / Modify (buttons)

Use these buttons to access the Connection name dialog box. Use the dialog to specify a Connection Name.

When done, click OK.

Delete (button)

To remove a Connection Name, highlight a value in the list and click Delete.

Time Ranges

Time ranges for each connection branch.

Add Time / Modify Time (buttons)

Use these buttons to access the Range of Hours dialog box. Use the dialog to specify a Start Time and End Time from the lists.

Delete Time (button)

To remove a Time, highlight a value in the list and click Delete.