1. Documentation
  2. All
  3. Aironet Developer Platform
Aironet Developer Platform
  • Cisco Aironet Developer Platform Quick Start Guide
    • About Aironet Developer Platform
      • Development Process
      • About This Guide
    • Module Development Guidelines
      • Module Connectivity
      • Constraints
      • Design and Installation
    • HDK Block and Power Diagrams
      • Block Diagram
      • Power Diagram
    • HDK Elements
      • Specifications At-A-Glance
      • Ethernet
      • I2C/SMI Address Assignments
      • MAC Address Assignments
      • Serial IDPROM
      • Power and I/O Interfaces
        • Power and I/O Ports
        • Onboard Power Supplies
        • Power Input
        • Power Output
      • Signal Header and Control Pins
        • Ethernet Addresses and Signal Header Connections
        • Golden Finger Connector Pin Assignment
        • Headers and Control Pins
        • Power I/O Control
        • Sensor Control Pin
      • LED Indicators
    • HDK Mounting and Installation
    • Single Board Computer Support
    • WLC Configuration
    • Additional Resources
      • IVT & Compliance
    • Community and Support
      • Developer Support
      • FAQs

LED Indicators

Ethernet Description LED Behaviour
D1 Ethernet switch On = enable, Off = disable
D2 P3 Link/Activity Off = no link, On = Link, Blink = activity
D3 P3 Speed On = Gig link
D9 P4 Link/Activity Off = no link, On = Link, Blink = activity
D10 P4 Speed On = Gig link
D8 PoE On = PoE on, Off = PoE off, 0.4Hz Blink = Power Management event, 0.8Hz Blink = Overload, or short 3.3Hz Blink = Vmain out of range or Over Temp
D13 XBee RSSI
D14 XBee Associated -
Next